[Elecraft] K3 SSB got lost = Solution

[Tommy]

Again thanks to all who actually read my post and offered helpful
suggestions.

I have finally discovered the infamous operator error that caused my K3 to
lose rcvr audio when I would change modes from CW to SSB.

As mentioned in my original post, for the past 61 years I have been
primarily a CW operator, therefore seldom paid close (enough) attention to
the settings for the voice modes. Therefore when setting up the Rx
Equalization, I set it up for CW with the below setting:

50	100	200	400	800	1600	2400	3200

-16	-16	-6	+15	+16	-15	-16	-16

AND I did not set up Rx Equalization for USB/LSB. I did save the
configuration for CW. Obviously when I switched to USB or LSB, I could hear
no voice audio. It was only after discovering my 'operator error' I changed
USB/LSB to:

-16	-16	+16	+8	+12	+12	+12	-16

And now I have normal audio (to my ears) in all three modes.

Thanks again for your helpful suggestions and let's close this thread.

73,
Tom - W4BQF