[Elecraft] FW: K3 - SSB audio get lost !

[Tommy]

From: Tommy [mailto:aldermant at windstream.net] 
Sent: Wednesday, October 23, 2013 10:17 PM
To: 'elecraft-bounces at mailman.qth.net'
Subject: RE: [Elecraft] K3 - SSB audio get lost !

 

Thanks to all asking about my filter configuration.

 

I have my 2.7kc/1.0kc/0.5kc/0.3kc filters all enabled for CW/ LSB/ USB/ and
DATA.

 

And to clarify my original post, I am talking about receive audio and not
transmitted audio. 

 

73,

Tom - W4BQF

 

 

 

From: John Parker [mailto:johnj1jr at verizon.net] 
Sent: Wednesday, October 23, 2013 10:04 PM
To: Tommy
Subject: Re: [Elecraft] K3 - SSB audio get lost !

 

Is it possible that your 2.7/2.8 Khz filter is not selected for SSB in the
configuration?

Good luck with this, 73, John WB4UHC

 

 

  _____  

From: Tommy <aldermant at windstream.net <mailto:aldermant at windstream.net> >
To: elecraft at mailman.qth.net <mailto:elecraft at mailman.qth.net>  
Sent: Wednesday, October 23, 2013 10:39 AM
Subject: [Elecraft] K3 - SSB audio get lost !


I am having a configuration issue that I have spent hours trying to figure
out and need some help please.

As a CW person, I seldom operate SSB and I am trying to get set up for this
weekend's CQWW SSB test. Below are some of my configuration for my K3 and
the attached are jpg configuration sheets from K3 EZ. In any band in the SSB
portion, I have no audio output any time I am in the USB or LSB mode,
however if I change from USB to CW, I have normal audio but of course I
can't copy the SSB signals. This is true whether I have my SUB turned on or
not. I have my CM-500 headset plugged into the rear of my K3 and I have the
RS20S headset plugged into the front panel PHONES jack and I have no audio
with either or both of the headsets plugged in. With both headsets removed,
I have no speaker audio in the SSB mode, but normal audio in the CW or AM
mode.

Any helpful suggestions would be greatly appreciated!

In CONFIG I have:

SPKRS = 1
SPKR+PH = YES
L-MIX-R = A  b

Thanks for your input and 73,

Tom - W4BQF

PS: I have been trying to configuration pictures from K3-EZ but nothing is
getting onto the reflector.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net <mailto:Elecraft at mailman.qth.net> 

This list hosted by: http://www.qsl.net <http://www.qsl.net/> 
Please help support this email list: http://www.qsl.net/donate.html