[Elecraft] K3 - SSB audio get lost !

[Jim Bennett]

I think I found it - try looking in your K3 Utility, under the Crystal Filter Configuration - there you will find the enable / disable for USB and LSB for each of the filters you have installed.

Hope that cures your problem!

Jim / W6JHB


On   Wednesday, Oct 23, 2013, at  Wednesday, 7:39 AM, Tommy wrote:

> I am having a configuration issue that I have spent hours trying to figure
> out and need some help please.
> 
> As a CW person, I seldom operate SSB and I am trying to get set up for this
> weekend's CQWW SSB test. Below are some of my configuration for my K3 and
> the attached are jpg configuration sheets from K3 EZ. In any band in the SSB
> portion, I have no audio output any time I am in the USB or LSB mode,
> however if I change from USB to CW, I have normal audio but of course I
> can't copy the SSB signals. This is true whether I have my SUB turned on or
> not. I have my CM-500 headset plugged into the rear of my K3 and I have the
> RS20S headset plugged into the front panel PHONES jack and I have no audio
> with either or both of the headsets plugged in. With both headsets removed,
> I have no speaker audio in the SSB mode, but normal audio in the CW or AM
> mode.
> 
> Any helpful suggestions would be greatly appreciated!
> 
> In CONFIG I have:
> 
> SPKRS = 1
> SPKR+PH = YES
> L-MIX-R = A   b
> 
> Thanks for your input and 73,
> 
> Tom - W4BQF
> 
> PS: I have been trying to configuration pictures from K3-EZ but nothing is
> getting onto the reflector.
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html