[Elecraft] K3 and Signalink USB

[Brendon Whateley]

When I use Data-A on the KX3, FLDIGI shows the incorrect operating frequency and I don't know how to fix that.  The frequency is correct when I use the side band.

- Brendon
KK6AYI

On May 30, 2013, at 2:53 PM, Greg wrote:

> And always best to use Data-A for data modes via soundcard (or AFSK-A
> for RTTY).  This will help with a clean signal by keeping compression
> turned off to avoid over-driving the audio chain.
> 
> 73
> Greg
> 
> 
> On 5/30/13, David Sanders W4DES <w4des at sandersweb.net> wrote:
>> I'm using the SignaLink USB.  SignaLink sells various cables to hook up to
>> different radios.  You need to get the cable part no. SLCABK3.  It plugs
>> into the line input, line output and PTT input jacks on the back of the K3.
>> In addition, you will reconfigure some jumper wires inside the SignaLink
>> USB.  Instructions come with the cable.
>> 73,
>> David Sanders W4DES
>> K3 (7409)
>> 
>> 
>> 
>> On May 30, 2013, at 5:37 PM, Richard W Hemingway <rheming1 at sbcglobal.net>
>> wrote:
>> 
>>> Hi,
>>> 
>>> I think that I may have messed up and it got away from me.  What I was
>>> asking is whether any of you are using SignaLink USB. Where do the cables
>>> plug in on the back of the K3. Do you have to turn on Data or can you use
>>> SSB?  I have written to SignaLink but have not received an answer.  I know
>>> that you don't have to use SL for PSK, and I may not go that way, but I
>>> have it for the rig I just sold and Would like to use it if I can.
>>> 
>>> Dick, N5XRD