[Elecraft] K3 Setup Failing

[Brian F. Wruble]

Red light, yes.
Arrow points to VFO A
TX is steady




*Brian F. Wruble, C.F.A.

*70 is the new 40.*
*
Mail: 1107 Key Plaza, PMB 447 Key West, FL 33040-4077
Summers: P.O.Box 57, 7400 Augustine Herman Highway, Georgetown, MD 21930
eFax  305.768.0278







On Sat, May 25, 2013 at 9:04 PM, Ed <edwest at sisqtel.net> wrote:

> Brian
>
> There are two other things you can check.  On the K3, when pressing the
> “Xmit” button,
> the one above the volume control, does the red “Xmit” LED light?  It is
> located above the
> “Phones” jack.  If not look over on the extreme right of the display.
>  There is an arrow
> that indicates which VFO you are transmitting on.  Just below, or above,
> the arrow will be
> “TX”.  If TX is steady in it’s state you should be seeing power out and
> the Xmit LED should
> light.  If the “TX” is flashing, this indicates that the K3 is in “Test
> Mode”.  Test mode will
> inhibit Xmit and the red LED will not light.  This function is toggled
> pressing and holding
> the grey “Mode” button.
>
> If nothing here helps I suggest calling Elecraft for help.  They will
> treat you very well.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>