[Elecraft] K3 Setup Failing

[bwruble at gmail.com]

Thanks.  That is not the answer, but please keep thinking! 

It worked once, and I have obviously set something wrong.  

Brian


-- 
70 is the new 40.

Brian F. Wruble, C.F.A.
1107 Key Plaza, PMB 447 Key West, FL 33040 
Summers: P.O.Box 57, 7400 Augustine Herman Highway, Georgetown, MD 21930    
eFax  305.768.0278   Skype   bwruble   


On May 25, 2013, at 9:04 PM, "Ed" <edwest at sisqtel.net> wrote:

> Brian
> 
> There are two other things you can check.  On the K3, when pressing the “Xmit” button, 
> the one above the volume control, does the red “Xmit” LED light?  It is located above the 
> “Phones” jack.  If not look over on the extreme right of the display.  There is an arrow 
> that indicates which VFO you are transmitting on.  Just below, or above, the arrow will be 
> “TX”.  If TX is steady in it’s state you should be seeing power out and the Xmit LED should 
> light.  If the “TX” is flashing, this indicates that the K3 is in “Test Mode”.  Test mode will 
> inhibit Xmit and the red LED will not light.  This function is toggled pressing and holding 
> the grey “Mode” button.  
> 
> If nothing here helps I suggest calling Elecraft for help.  They will treat you very well.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html