[Elecraft] XMIT Cycling in K3

[Jay]

Found it...does N1MM have a mind of its own?

Found the CQ repeat enabled..and there is no reason for me to even check 
that off......


----- Original Message ----- 
From: "Jay" <pcb4u at verizon.net>
To: <elecraft at mailman.qth.net>
Sent: Friday, May 24, 2013 4:22 PM
Subject: [Elecraft] XMIT Cycling in K3


> After loading the new released files today with the new utility (all went 
> fine) for the K3, when I now use N1MM and call CQ it keeps on cycling the 
> CQ (XMIT to RX and then again XMIT over and over)..just keeps on looping 
> until I hit escape in N1MM
>
> This occurs in CW and RTTY modes
>
> Never did this before
>
> HUH?
>
> Jay
> W2IJ
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html