[Elecraft] Connector for K2 Mic. Config. header

[Don Wilhelm]

Chris,

I use one of the "computer" 2 pin jumpers - try to find one with an open 
slot at the top.  Solder the wire to the center of the exposed top 
metal.  Plug one side of that jumper onto the Mic Configuration Header 
using an unused pin.  If you use the Elecraft pinout, the "Func" pin has 
no function, so plug it onto the mic jack side of pin 5.  Use a wire 
that is long enough to lift the Control Board and reach the mic 
configuration header and attach/detach the connector.

73,
Don W3FPR

On 5/20/2013 5:36 PM, Chris Kimball wrote:
> I'm ready to install a W3PFR/N0SS fixed audio out amp; however, a single,
> slip-over connector for the microphone configuration header is needed to
> bring the output to the mic connector.  The header pins look a lot like
> large, wire-wrap pins, but I'm not sure.  The audio board is going on the
> control board a la N6TQS, so the header connection needs to slip off.
>
> Does anyone have a suggested part number, or, better yet, have one they
> could spare?
>
> Thanks,
>
> Chris
> NQ8Z
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/Connector-for-K2-Mic-Config-header-tp7573939.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>