[Elecraft] Connector for K2 Mic. Config. header

[Chris Kimball]

I'm ready to install a W3PFR/N0SS fixed audio out amp; however, a single,
slip-over connector for the microphone configuration header is needed to
bring the output to the mic connector.  The header pins look a lot like
large, wire-wrap pins, but I'm not sure.  The audio board is going on the
control board a la N6TQS, so the header connection needs to slip off.

Does anyone have a suggested part number, or, better yet, have one they
could spare?

Thanks,

Chris
NQ8Z



--
View this message in context: http://elecraft.365791.n2.nabble.com/Connector-for-K2-Mic-Config-header-tp7573939.html
Sent from the Elecraft mailing list archive at Nabble.com.