[Elecraft] K2 VFO dial

[Mike Harris]

Hi Jean,

Measured at 37mm for a knob from a vintage 2000 K2 #1400.  So, two 
measured at 37mm and one suggestion of 1.6 inches (40.64mm).  Any 
advance, going once, twice......

A popular replacement in the early years was the knob from a Yaesu 
FT100.  Nice rubber ring on it and a not too useful finger dimple.  So 
many FT100 knobs ordered that apparently Yaesu thought there was a 
quality control problem.

Regards,

Mike VP8NO

On 10/05/2013 10:10, Behiels JeanPierre wrote:
> Hi Elecraft members
>
> Is there any K2 builder witch could give me the exact diameter(mm or inches) value of the standard delivered VFO dial knob of the K2 rig ,I like to now.
>
> Regards Jean ON4AEF.