[Elecraft] POWER SETTING DISPLAY

[Bob]

Well not quite everyone.  As a subreceiver owner I love the concept and would 
suggest that this feature be available for all.  I can see it being there when 
the subreceiver is not in use..   That could another option to select.

Admittedly I have no clue as to how much programming effort we are asking for 
and also at some point there will be hardware limitations too.  The program and 
setting storage space is not infinite.

The use of the subreceiver  in my case is pretty limited to split usage while 
chasing DX.   It can be seen on the P3 so maybe even a "Marco" to turn it on or 
off could be used too.

73,
Bob
K2TK  ex KN2TKR (1956) & K2TKR .



On 5/6/2013 1:40 AM, Gary Gregory wrote:
> I would rather see a lot more options to display in VFO B...everyone would
> be happy then...:-)
>
> 73
>
> On 6 May 2013 15:06, Bill Frantz <frantz at pwpconsult.com> wrote:
>
>> I'd rather have the DSP filter information. High and low cutoff or center
>> frequency and bandwidth depending on which mode is set for the controls.
>>
>> YMMV - Bill, AE6JV
>>
>> On 5/6/13 at 9:55 PM, val at vip.bg (Val) wrote:
>>
>>   I wish we had there the CW speed too. There is a place for both values.
>>> 73, Val LZ1VB
>>>
>>> Can the K3 Sub Receiver display (without the 2nd receiver installed) be
>>> programmed to show the power setting as a selectable continuous display as
>>> opposed to the power setting flashing when the PWR knob is turned?
>>> ...
>>> Allen Griffith N5AG K3 #03547
>>>