[Elecraft] POWER SETTING DISPLAY

[Gary Gregory]

I would rather see a lot more options to display in VFO B...everyone would
be happy then...:-)

73

On 6 May 2013 15:06, Bill Frantz <frantz at pwpconsult.com> wrote:

> I'd rather have the DSP filter information. High and low cutoff or center
> frequency and bandwidth depending on which mode is set for the controls.
>
> YMMV - Bill, AE6JV
>
> On 5/6/13 at 9:55 PM, val at vip.bg (Val) wrote:
>
>  I wish we had there the CW speed too. There is a place for both values.
>>
>> 73, Val LZ1VB
>>
>> Can the K3 Sub Receiver display (without the 2nd receiver installed) be
>> programmed to show the power setting as a selectable continuous display as
>> opposed to the power setting flashing when the PWR knob is turned?
>> ...
>> Allen Griffith N5AG K3 #03547
>>
>
> ------------------------------**------------------------------**
> -----------
> Bill Frantz        | I don't have high-speed      | Periwinkle
> (408)356-8506      | internet. I have DSL.        | 16345 Englewood Ave
> www.pwpconsult.com |                              | Los Gatos, CA 95032
>
> ______________________________**______________________________**__
> Elecraft mailing list
> Home: http://mailman.qth.net/**mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>
> Help: http://mailman.qth.net/mmfaq.**htm<http://mailman.qth.net/mmfaq.htm>
> Post: mailto:Elecraft at mailman.qth.**net <Elecraft at mailman.qth.net>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>



-- 
*Gary - VK1ZZ
Skype: Gary.VK1ZZ
Motorhome Portable
The Shack*
*Elecraft K3
P3 Panadapter
KPA500FT
KAT500FT**
KX3-K
*