[Elecraft] Remote KPA500 Via Moxa - On/Off Switch via S/W not stable

[mcduffie at ag0n.net]

On Fri, 22 Mar 2013 15:54:21 -0700, Dick Dievendorff wrote:

> I've just done a little tweaking to the KPA Utility's timing.  After the
> power off command is issued it takes a little while before the KPA500 is
> responsive to any other serial commands.  The KPA Utility doesn't wait quite
> long enough.

Dick,

Any word on a change to allow the TS-590 band information to be properly read by
the KPA when using memories?  As previously reported, it works fine in VFO mode,
but does not when operating in memory mode.

Gary McDuffie
AG0N