[Elecraft] K1 band change Issue

[William LeComte]

Thanks Don, I'll try that.

73,

Bill  KB1DX


On Mon, Jun 17, 2013 at 4:24 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:

> Bill,
>
> Go into the K1 menu and change the "b2" menu parameter from 14 to 10.  If
> the 4 band board has the 18.1 kHz crystal at X3, tap DISPLAY to change the
> parameter from 10.0 to 10.1.
>
> 73,
> Don W3FPR
>
>
> On 6/17/2013 3:27 PM, William LeComte wrote:
>
>> I purchased a used pre-built K1 from a friend with a known issue in the 4
>> band module. My 4 band module covers 40, 30, 20, and 15 meters but 30
>> meters does not function.  What I observed is when the Band switch is used
>> to cycle through the bands 30 meters does not show up in the display, but
>> 20 meters appears to show up twice.  One of the appearances of 20 meters
>> functions, but the other does not, which is likely 30 meters not being
>> recognized and showing up as 20 meters.  Any suggestions as to what would
>> cause 30 meters to not be recognized?
>>
>> Bill
>> ______________________________**______________________________**__
>> Elecraft mailing list
>> Home: http://mailman.qth.net/**mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>
>> Help: http://mailman.qth.net/mmfaq.**htm<http://mailman.qth.net/mmfaq.htm>
>> Post: mailto:Elecraft at mailman.qth.**net <Elecraft at mailman.qth.net>
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>>
>