[Elecraft] [K3] Aux RF

[Jim Miller]

Hi Ron

Thanks for the info. I had just discovered it as well in the KRX3 manual.
I'll have to fire up a XGen to see which way I connected it when I
installed it.

73

jim ab3cv


On Sun, Jun 16, 2013 at 6:15 PM, Ron D'Eau Claire <ron at cobi.biz> wrote:

> That's right Jim:  You can have the subrx use ANT1 or ANT2 out of the KAT3,
> whichever is NOT being used for xmit or you can connect the AUX RF input.
>
> See the KRX3 Installation and Operation manual. It's available on the
> Elecraft WEB site here:
>
>
> http://www.elecraft.com/manual/KRX3_Subreceiver_Install-Operate_Manual_Rev_E
> .pdf
>
> Pages 25 and 26 show the optional ways to connect the subrx antenna input
> either to the KAT3 or to the rear-panel AUX RF input.
>
> Page 43 shows the MENU settings required.
>
> 73 Ron AC7AC
>
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jim Miller
> Sent: Sunday, June 16, 2013 2:24 PM
> To: Elecraft Reflector
> Subject: [Elecraft] [K3] Aux RF
>
> I've got a little LF converter to play with an I thought I'd use it with
> the
> AUX RF input and the SUBRX.
>
> I've got a PR6 and beverages connected to the normal RX path and I don't
> want to mess with that.
>
> I seem to remember there was a wiring election when putting in the KAT3. Do
> I remember that right? Taking one election meant not being able to use the
> AuxRF. I could be confused...
>
> Just thought I'd ask before taking the K3 apart unnecessarily.
>
> 73
>
> jim ab3cv
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>
>