[Elecraft] Troubleshooting dead subRX after adding filter

[Pete Smith N4ZR]

Thanks, Arie. I found the problem. the TMP connector on the cable 
running from J5 on the KREF3 board to J82 on the KRX3 had worked loose 
at the J5 end, where I couldn't see it until I removed the sub-RX again 
and the cable came away with it. All is well.

73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.

On 6/10/2013 7:21 AM, Arie Kleingeld PA3A wrote:
> Pete,
>
> If all tmp cables are fitted right and the menu settings are OK, how 
> about the bottom-connectors to the K3 main-board?
>
> 73
> Arie PA3A
>
> Op 10-6-2013 13:08, Pete Smith N4ZR schreef:
>>
>>
>> I've checked and rechecked the crystal filter setup, the TMP cables, 
>> etc. Before I tear it open again, is there anywhere in particular I 
>> should be looking?
>>
>> 73, Pete N4ZR
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>