[Elecraft] fldigi, SignaLink - problems

[Matt Zilmer]

Make sure you're connected properly with Line In and Out.  Set the MIC
SEL to the correct input (Line In) while in TX DATA mode.

73,
matt W6NIA

On Sun, 09 Jun 2013 08:46:09 -0700 (PDT), you wrote:

>Hi,
>
>Mr K3 has arrived!!!  So far everything has gone well, except one thing. I am using
 a SignaLink USB, as I had one and used it on my formeer radio.  I
have the new cord and jumper wire card installed. It is connected to
the wire in, wire out, and PTT on the radio and into the SL, thence
into the computer.  I have changed Hamlib to K3 in the configure box.
I received just fine, but when I try to send it lights up the PTT
light in the Sl and the TX light on the K3, but no signal. The K3 mode
is set on USB, but the same result on Data>  I know that I am doing
something wrong.  Helpl!
>
>Dick, N5XRD
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html