[Elecraft] KXPA100

[Phil Hystad]

Sounds right.  When I saw the one in Seapac I thought that one of the dimensions was longer than the other.  That is why I said it was about the size of a P3 rotated but that is just a wild comparison -- I never measured it and only held it for about 3 seconds.

PEH

On Jun 7, 2013, at 9:16 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:

> I got a response from one of the developers working with the KXPA100 and the KXAT100 that the one his tape measure said it was 4 5/8 inches wide, 4 inches high and 9 inches in depth.  So my 'eye calibration' was not far off the actual dimensions.
> 
> 73,
> Don W3FPR
> -----------------------------------------------------------
> 
> The one I saw at Dayton was about 4.5 by 4.5 inches on the face (including the heat sink), and about 10 inches in depth.  Those measurements are not exact, and only represent the accuracy of my "calibrated eye".  The KXPA3 took up about 1 3/8 vertical inches of panel space and the vertical height of the KXAT3 was the same.
> 
> My 'eye' was 'calibrated' after 10 years of running a custom woodworking shop, where I was acclimated to making approximate measurements.  When the real measurements are revealed, it will be interesting to compare my approximations - my skills with that stuff are now 13 years old.
> 
> 73,
> Don W3FPR
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html