[Elecraft] ESSB Equalization

[Matt Zilmer]

Hi Ron,

Go the CONFIG:TX ESSB menu.  Push the '1' key until VFO A reads, On or
OFF.  If it's OFF, push the '1' key again and you should see it read
'On'.

Use VFO A to set the width you want.  Then exit the menu.

73,
matt W6NIA

On Sat, 26 Jan 2013 14:32:06 -0800, you wrote:

>Recently I was reviewing the ESSB settings and noticed in both the KE7X &
>factory manual, it says says there is an * setting for a separate equalizer
>just for ESSB.
>
>Supposedly when you set the K3 up for ESSB, and go to the TX ESSB setting
>in the config menu, you should see TX*ESSB and I assume this settings for
>equalization come up whenever you go back to the ESSB setting.
>
>I can't seem to get this to happen.
>
>now I can tweak the Xmtr equalizer just for ESSB and save it in EZ K3, but
>how do I get the TX*ESSB to work?