[Elecraft] BAND CODE OUTPUT CHANGE

[Dick Dievendorff]

I'm not sure this will do what you want done, but there is a KRC2 menu that
affects band decode.  See page 57 of the K3 owner's manual.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Mike Greenway
Sent: Friday, January 25, 2013 2:47 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] BAND CODE OUTPUT CHANGE

Without going into a long story why I need this, is there anyway to change
the band decode outputs?  Just need to change 6 M to 60 M decode.  Probably
not possible by firmware but thought I would ask.  I can do it externally
but it would make things easier to have the K3 send the code I want.  73
Mike k4pi ______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html