[Elecraft] K3 Receiver

[Don Wilhelm]

True, true, but ---
Ideally, that saved configuration file should be one that was obtained 
before the problem came up.
If a configuration file is generated right before the EEINIT, the same 
problem may be re-loaded afterwards.
Of course, whether that is true or not depends on the type of failure.

73,
Don W3FPR

On 1/25/2013 8:26 AM, Lee Trout wrote:
> Larry:
> Over the years I have had several intermittent, seemingly inexplicable
> problems with the K3 that have been solved simply by doing a EEINT (see K3
> manual) and a reload of the firmware.  If you haven't found a hardware
> problem, this may be worth a try since it doesn't take long to do.  Just be
> sure to save your configuration before you do the EEINT so you can reload
> your settings after, and use the SEND ALL FIRMWARE TO THE K3 in the utility.
> Lee, K9CM
>