[Elecraft] [K3] Ref Cal failed

[Ron D'Eau Claire]

Sri if it's obvious, but is XIT or RIT enabled? 

73, Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Martin
Sent: Thursday, January 24, 2013 1:11 PM
To: elecraft
Subject: [Elecraft] [K3] Ref Cal failed

Elecrafters,
a fellow ham kept telling me i am off frequency, so i performed the CAL REF
Method2 per the instruction manual.
A 10m ssb qso with him showed that i now am within a few hz to his rx.
I then had a qso on 80m with a few SDR-guys. They told me i'm off about
100hz. I trust them. I don't remember anyone complaining about me beeing off
freq on 80m before.

What did i miss? Any other parameter to check?

Method 2
Before the calibration the K3 had a warm-up for at least 2 hours.
10Mhz WWV,
CONFIG:REF CAL.
S P O T on
Matched beat note to sidetone.
Accuracy to my ears was less than 1 hz (as a cw op i'm good at this)


73,
Martin




______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html