[Elecraft] KX3 Mode Status and N1MM

[N4CW at aol.com]

While operating the NAQP SSB last night using my KX3 and properly  
configured for KX3 operation, I noticed an "error" message of sorts. It appeared  at 
the bottom of the Entry Window and said, "K3 Sub-Mode PSK-D
not supported". This happened only on 20M and didn't affect logging nor  
operation! The message was conspicuously absent on 15 and 10 (all on USB) and 
40  and 75 meters.
 
So today, I decided to check things out. What I find is that if I'm  
operating 20M SSB and using N1MMLogger, I get the "error" message. Then, if I go  
into DATA mode, I find that it's set at PSK-D while
the "error" message is displayed. If I change the mode to AFSK-A, or any  
mode other than PSK-D, the "error" message goes away.
 
Now you'd think that while I was in SSB/USB mode, that the PSK-D setting  
information wouldn't be sent to
N1MM...
 
Am I doing something wrong?
 
Bert, N4CW