[Elecraft] KX3 with KAT500 and KPA500

[eric norris]

The KX3 will work fine with the KAT500 without disconnecting anything.  If you have set the tuning solutions previously with the K3 it will automatically select the antenna and solution--but not autotune.

To use the KPA500 with the KX3 you must disconnect the Elecraft cable carrying band data or it will not bandswitch.  I don'think this could be fixed in firmware but it would be really cool if it could.

I found it highly amusing to watch my KAT500 switching--and even autuning--with the fleet of boat anchors I used on straight key night.

73

Eric WD6DBM

Sent from the metering jack on my Heathkit Twoer