[Elecraft] [KX3] Transverter Band TX output

[Jimk8mr at aol.com]

I'm working at getting my DEM transverters interfaced to the KX3. I've set  
up the first three XVTR bands, configured for 28 MHz IF. With the KX3 max 
power  set at 0.1W on the transverter bands, I'm only getting about 20 mW of 
28 MHz RF  output (1V RMS measured on the scope). When I use 28 MHz with the 
power 
set at 0.1W I'm showing about 350 mW (4V RMS). 
 
I can increase the RF power by increasing the KX3 max power setting, but  
still it is much lower on the XV bands than on 28 MHz.
 
The absolute numbers may not be very accurate, but why the big  difference?
 
 
73  -  Jim   K8MR