[Elecraft] KX3 encoder: mechanical noise?

[K4THE]

Newbie here with KX3-K #3049. My encoder shaft had 2 very tight spots as I
turned the shaft - even without the knob attached. I hoped it would go away
but after a week of use it was still very tight. I removed encoder and could
see the C-clip and the washer underneath rotating on the threaded shaft. I
applied a drop of 3-in-1 oil to washer & clip and worked it in well: turning
shaft while pushing it in and pulling out, more oil - repeat. Reinstalled
encoder and knob. It now turns smoothly and is 95% better. 73 Dennis K4THE



--
View this message in context: http://elecraft.365791.n2.nabble.com/KX3-encoder-mechanical-noise-tp7559447p7568186.html
Sent from the Elecraft mailing list archive at Nabble.com.