[Elecraft] [KX3] KX3 BETA firmware release (rev 1.34) -- Digital Voice Recorder (DVR)
Christian AK4VV
ak4vv at kuhtz.com
Wed Jan 2 20:44:55 EST 2013
Thank You both! Much appreciated.
73,
Christian
AK4VV
On Jan 2, 2013 8:14 PM, "Wayne Burdick" <n6kr at elecraft.com> wrote:
> KX3 beta firmware rev 1.34 (with DSP rev 1.04) is now available. This
> release includes the new DVR feature, with two transmit messages of up
> to 15 seconds each. See full instructions in the release notes below.
>
> (By the way, I'd like to thank Lyle, KK7P, for his efforts in getting
> the KX3's DSP to access flash memory efficiently for DVR purposes. He
> had to rewrite a lot of the DSP manufacturer's own access routines. I
> think he achieved some of this while on vacation...don't tell his XYL.)
>
> You'll need the KX3 Utility application to download and install
> firmware. For full instructions, refer to our KX3 software page:
>
> http://www.elecraft.com/KX3/KX3_software.htm
>
> Wayne
> N6KR
>
> * * *
>
> MCU 1.34 / DSP 1.04, 12-31-2012
>
> * DVR (DIGITAL VOICE RECORDER) ADDED: There are two transmit messages
> of up to 15 seconds each. Message chaining and other message-length
> options will be added in a future release.
>
> Setup: Make sure you’re in a voice mode, and that the voice MONitor
> level is not zero. Typical MON level is 5-10. Message record and play
> will work with either VOX or PTT selected.
>
> To record, hold REC, then tap #1 or #2. “ERASING” will appear for 4
> seconds, followed by “TAP XMT”. Tap XMIT, then start speaking. To end
> recording, tap XMIT again.
>
> To play, tap MSG followed by a tap of #1 or #2.
>
> To play with auto-repeat (e.g., a repeating CQ message), *hold* rather
> than tap the #1 or #2 switch. Use MENU:MSG RPT to set the repeat
> interval.
>
>
>
>
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
> <*> To visit your group on the web, go to:
> http://groups.yahoo.com/group/KX3/
>
> <*> Your email settings:
> Individual Email | Traditional
>
> <*> To change settings online go to:
> http://groups.yahoo.com/group/KX3/join
> (Yahoo! ID required)
>
> <*> To change settings via email:
> KX3-digest at yahoogroups.com
> KX3-fullfeatured at yahoogroups.com
>
> <*> To unsubscribe from this group, send an email to:
> KX3-unsubscribe at yahoogroups.com
>
> <*> Your use of Yahoo! Groups is subject to:
> http://docs.yahoo.com/info/terms/
>
>
More information about the Elecraft
mailing list