[Elecraft] K3 Manual Error? Software error?

[Don Wilhelm]

Lew,

The manual is not correct.  That has been pointed out before and will be 
corrected.

73,
Don W3FPR

On 2/27/2013 5:02 PM, Lewis Phelps wrote:
> I recently acquired a Kenwood MC-90 desk mic from a "for sale" list posted here. It's a great microphone, but with a VERY low output level.  Even with MIC GAIN cranked all the way up to 60, it wouldn't move the ALC indicator unless I literally shouted into it. (Yes, I had selected "FP-H on the mic setup.)
>
> Then I found the following in the K3 Operating Manual, page 52:
> For the front-panel mic only, tap [3] to turn on an additional gain stage. Use this only with very low-output mics. An apostrophe will appear after the H , e.g. H ’ .
>
> I rushed to try that.  Result:  "N/A".
>
> But....while fiddling around trying to find out why the [3] button wasn't doing what it was supposed to do, I more or less accidentally tapped the [7] button, and the magic apostrophe appeared after the H.  And most importantly, I now have enough amplification for the Kenwood mic to be functional.
>
> It would seem that there are only two explanations for this:
>
> 1. The manual is wrong.
> 2. Bad firmware.
>
> Anybody know which answer is correct?  I have no way to tell.
>