[Elecraft] XV144 drops power if "PWR" is moved during xmit inUSB mode

[KD7YZ Bob]

On Tuesday Lemay used a Straight-Key to send:
-------------Original Comment-------

> ... I suggest you run
> through the TX Gain Calibration routine, which is in the manual – pay
> ... I’m not 100% convinced this
> will help, because you say that the 432MHz transverter behaves fine.


as does the XV50 I own.

I just connected the 50-ohm Dummy Load and ran thru the three
transverters. Only the xv144 behaves oddly



-- 
Best regards,
Bob  KD7YZ    Win7-64bit + K3