[Elecraft] Screw Confusion

[pirey4]

I was very excited to receive my KX3 kit today.  Assembly was going fine
until I got confused about what screws to use on the front panel assembly. 
(I'm using Rev. F of the assembly manual).

Figure 14 on Page 14 of the assembly manual shows a single 4-40, 3/16"
(4.8mm) black flat head screw used to secure the bottom of the bezel to the
front panel assembly.

Figure 19 on Page 17 shows four 4-40, 3/16" (4.8mm) black flat head screws
used to fasten each side panel to the front panel assembly.

This is a total of five 4-40, 3/16" (4.8mm) black flat head screws.

Since Page A3 shows four 4-40 3/16 (4.8mm) black flat head screws in the
parts list and four of these screws was included in the Front Panel Hardware
bag, I would assume that only four of these screws are needed. 
Unfortunately, I see five of them being used in the assembly process.  

There are a couple of extra screws of this size in the "spare parts bag". If
I actually need 5 of these screws, I'll take one from there but I want to
make sure I'm using the correct size everywhere.

I've already had to borrow three #2 lock washers and one #4 lock washer from
the spare parts bag.

Thanks,

phil (K4PMI)



--
View this message in context: http://elecraft.365791.n2.nabble.com/Screw-Confusion-tp7569978.html
Sent from the Elecraft mailing list archive at Nabble.com.