[Elecraft] K3 / N1MM & PTT footswitch for ESM

[Don Wilhelm]

Bill,

The transmit/receive information will be sent to N1MM in response to an 
IF command issued by N1MM or in response to a TQ command (again issued 
by N1MM).  The TX.RX state is not included in the AI meta command (see 
the K3 prorammer's reference).

You may have to ask the N1MM forum for additional information.  I am not 
sure what commands are used when N1MM polls the K3/

73,
Don W3FPR

On 2/9/2013 4:36 PM, Bill - W4RM wrote:
> I need a little help getting my K3 with footswitch plug into the back of the
> K3  "PTT IN" to key the Enter Send Mode (ESM) in N1MM.  I'm assuming there
> is a way that I can pass the footswitch closure through the K3 radio and
> using LP Bridge into N1MM to act as if I hit "Enter" on the keyboard.
>
>   
>
> So far I have not luck in making it work.
>
>   
>
> Configuration
>
>   
>
> K3 on com 3 connected to computer
>
> LP Bridge passing K3 to Comm 6 in N1MM (radio interface working)
>
> CW keying is winkeyer usb on Comm 4 (Working)
>
> N1mm set for ESM and that is working
>
>   
>
> But I can't figure out the setting to have the PTT from the footswitch in
> the back of the radio make it into N1MM to key ESM.
>
>   
>
> Any help would be great!
>
>   
>
> Thanks
>
>   
>
> 73 Bill  W4RM
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>