[Elecraft] External Sequencer / Amplifier Keying

[Kevin Hobbs]

Hi All

 

I am new to this list . had my K3/10 sitting on the shelf for the last 6
months as I made the transition from a Flex-5000A VU.

 

I am now scrambling get everything hooked up and running again. I only
operate 6m and 2m (plan on using external LT2S Transverter, but I may get
the internal unit). Always doing the opposite to the masses.

 

Since I use external amplifiers and preamps, I use sequencers and split RX
and TX coaxs. Plan to use ANT1 and RX Ant In for 6m and XVTR IN & OUT for 2m
(hopefully this will work).

 

The question is . is there a simple way that I can get a unique TX GND
signals for 6m and 2m to drive the sequencers?

I read about using Acc Pin 10 Keyout LP for 2m and standard rear Key Out for
6m, but I suspect that Key Out will be active on 6m and 2m?

 

Suggestions?

 

I am guessing that I will have plenty more questions as I try to get
everything including LP-Pan 2, Signal Link, and WSJT running to get back on
EME quick.

 

Thanks and 73

Kevin VE3KH