[Elecraft] Info on front panel LEDs

[Matthew Zilmer]

You might want to try setting the LCD and/or LED levels again, using MENU.  If the panel LEDs and LCD backlight both come on when you power up, there isn't anything wrong with the hardware.

73,

Matt Zilmer
Consultant - Product Management Dept.
Magellan Navigation / MiTAC Digital Corp.
Tel: (909) 394-6052
Cell: (909) 730-6552
In status quo voluntas non sufficit


-----Original Message-----
From: elecraft-bounces at mailman.qth.net [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dale Huffington
Sent: Tuesday, February 05, 2013 10:32 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Info on front panel LEDs

Hi - my first message, so please advise if I should address my help request to someone else.  I was moving up the bands to look for sounds of activity, and when I hit 18 mHz there was a "pop" from the rear and the panel lights went out.

Receive and transmit functions seem ok for CW.  I haven't tried sideband yet.

I have not found anything in the instruction manual concerning turning the Panel LEDs on or off.

The lights come on when the power first comes on, but when boot-up is complete, the lamps go out. I suspect I pushed two buttons inadvertently ("band" and "menu" perhaps?

Any suggestions will be much appreciated.
73, Dale,  AE0S
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html