[Elecraft] K2 VCO Alignment only 0.02V @ R30

[JeremyJones]

Looking over the board I did find that I had U8 C45 connected to pin7 instead
of pin6.  That has been corrected.

U6 pin 24 to U4 pin5 is less than 1 ohm, however U6 pin24 to U7 pin2 is 300k
ohm.  I don't see any damage on the board.

I also noticed going back to the beginning for the resistance checks on the
control board that Q1 collector should be great than 1M, but is reading 5k.



--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-VCO-Alignment-only-0-02V-R30-tp7569523p7569578.html
Sent from the Elecraft mailing list archive at Nabble.com.