[Elecraft] Serial Cable routing

[Dick Dievendorff]

You have it right, Fred.

 The only serial daisy chain is from PC to P3 to K3.  The amp and KAT500 have independent connections to a PC.  There is a15 pin ACC cable from K3 thru KAT500 to KPA500.

83 de Dick, K6KR

> On Dec 30, 2013, at 20:06, Fred Jensen <k6dgw at foothill.net> wrote:
> 
> So iPad [I can say that because I actually know you're a human being, you hiked me a couple of miles to the In-N-Out :-)], what am I missing here?  The instructions told me to go to the P3 before the K3, and to put the KAT500 in between the K3 and KPA500.  This has worked for me from the very beginning, not long after the Big Bang, and for ever after ... well, at least as far as we've gotten.
> 
> Full Disclosure:  The computer now goes to a little boardie-thing from Pignology that runs my PigKnob, and then to the P3.  The rest is all the same, and it all works, still.
> 
> I thought the KAT would interrupt the KPA key line when tuning, thus it happens before the KPA on the 15-wire Elecraft Network?  Oh so much to learn.
> 
> 73,
> Hen 
> Fred K6DGW
> - Northern California Contest Club
> - CU in the 2014 Cal QSO Party 4-5 Oct 2014
> - www.cqp.org
> 
>> On 12/30/2013 6:48 PM, Jack Brindle wrote:
>> Computer - P3 - K3
>> Computer - KPA500
>> Computer - KAT500
>> 
>> Neither the KPA500 nor the KAT500 are involved in the P3/K3 serial port chain.
>> 
>> Jack Brindle, W6FB
>> 
>> Sent from my iPad
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html