[Elecraft] Serial Cable routing

[Fred Jensen]

So iPad [I can say that because I actually know you're a human being, 
you hiked me a couple of miles to the In-N-Out :-)], what am I missing 
here?  The instructions told me to go to the P3 before the K3, and to 
put the KAT500 in between the K3 and KPA500.  This has worked for me 
from the very beginning, not long after the Big Bang, and for ever after 
... well, at least as far as we've gotten.

Full Disclosure:  The computer now goes to a little boardie-thing from 
Pignology that runs my PigKnob, and then to the P3.  The rest is all the 
same, and it all works, still.

I thought the KAT would interrupt the KPA key line when tuning, thus it 
happens before the KPA on the 15-wire Elecraft Network?  Oh so much to 
learn.

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2014 Cal QSO Party 4-5 Oct 2014
- www.cqp.org

On 12/30/2013 6:48 PM, Jack Brindle wrote:
> Computer - P3 - K3
> Computer - KPA500
> Computer - KAT500
>
> Neither the KPA500 nor the KAT500 are involved in the P3/K3 serial port chain.
>
> Jack Brindle, W6FB
>
> Sent from my iPad