[Elecraft] K3 - ERR BP1, XV3, AT3, IF1

[Don Wilhelm]

Jim,

It would appear that your K3 options are not being recognized at startup 
- that would be some problem with the AUXBUS responses when the options 
are polled.

If you have a saved configuration file, I would suggest doing an EEINIT 
(see Parameter Initialization in the manual).  After the EEINIT, do a 
configuration restore from K3Utility.  If you do not have that saved 
configuration file, you will have to go through the calibration steps 
manually and tell the K3 which options are installed after an EEINIT - 
all menu settings will be restored to the defaults.

If the list of ERR messages includes the KPA3, that would be reason 
enough to explain your intermittent power out issue.

If EEINIT does not fix it, an email to K3support is in order.

73,
Don W3FPR

On 4/22/2013 5:06 PM, Jim Miller wrote:
> These are intermittent.  They appear at power on just before the welcome
> message.   At first I thought it was only ERR BP1 but since I have realized
> that pressing the disp button also shows the others if I can do it fast
> enough to read them before they go away and into the welcome message.  They
> are getting more often and mostly do not go away with power down and up
> again.  Guess it is time to break it open.
>
>   
>
> I have also been have having occasional trouble with no power out.  This
> only happens from power on and not during operation once going.
>
>   
>
> Just wondering which is the real problem.  The last thing that was done and
> this is not "recent" is to remove my KIO3 bd and  install the KIO3A board so
> I can connect my internal 2 meter module (not yet done).  I don't think I
> had this problem before that.
>
>   
>