[Elecraft] IS command...only for main receiver? What about sub?

[Joe Subich, W4TV]

 > set link for the sub mode and issued the commands you mentioned.
 > It reset the main receiver but not the sub.

There is no "link" involved.

> So WinWarbler must do something like an A>B without you knowing it.

Winwarbler/Commander is not doing *anything* other than passing the
commands I specify.

 > The trick of the IS 9000 is cool though...didn't know that existed for
 > resetting the shift.

It's in the programmer's manual.  In addition to shifting between phone
and other modes, failure to use IS is particularly apparent when jumping
between DATA A and FSK D.

73,

    ... Joe, W4TV


On 4/11/2013 12:21 AM, tomb18 wrote:
> That's strange, just tried it.  Took DATA A for example, set a width and
> shift.  Went to BSET, set a different shift and BW, went back to the main
> receiver, set link for the sub mode and issued the commands you mentioned.
> It reset the main receiver but not the sub.  So WinWarbler must do something
> like an A>B without you knowing it.
>
> The trick of the IS 9000 is cool though...didn't know that existed for
> resetting the shift.
> 73's
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/IS-command-only-for-main-receiver-What-about-sub-tp7572463p7572479.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>