[Elecraft] KPA500 Problem

[Bob Cunnings]

I experience a similar thing. With KPA500 BAND CHG set to STBY and
using the KPA500 band buttons to change bands, it happens if the
KPA500 goes from OPER to STBY on band change. Elecraft support
confirmed the issue and said that it would be fixed in the next K3
firmware release.

Bob NW8L

>Fred,
>There is a known firmware issue which causes the K3 to sometimes "forget"
>to go back to 100W when switching the KPA500 from OPER to STBY.
>Mine has the same issue where I need to periodically reset the K3 PWR back
>up to 100W when operating the KPA500 in STBY.  So far the K3 remembers to
>go to the preset PWR output levels when the KPA500 is in OPER.
>Elecraft is supposed to address this issue in a future firmware  release.
>
>Mike  AC6JA