[Elecraft] I/O output level

[F5LCI]

Thanks Don,
After trying to compare these two audio signals, I have arrived at this
conclusion, valid for /my setup/ (e.g. noise from the laptop screen (look at
my page on QRZCQ):
IMHO the I/Q derived audio by the PC can be of some utility, but the KX3
does it better.
SDR receivers (I own a PMSDR) are pleasant, but the "IF" to audio stages are
another story : KX3 rules...

72 de FO/F5LCI


Don Wilhelm-4 wrote
> 
> There will be some latency - so you have "double latency" - once through 
> the KX3 and again through the panadapter software.  That may or may not 
> be troublesome.  If so, the only cure is another soundcard and the cable 
> to the headphone jack (and mic jack)
> 
> You will likely want to use that 2nd sound card (one for the panadapter 
> the other for digital modes), because the KX3 has no provision for 
> transmit using the I/Q signals - to transmit, one needs to inject the 
> tones into the microphone jack, so just accept that fact and add the 
> path from the headphone jack to the soundcard as well.
> 
> The "listen through" is nice because it does provide a 2nd receiver 
> function for CW and SSB modes, and the frequency separation can be 
> greater than the KX3 dual watch limitations.
> 
> 73,
> Don W3FPR
> 




--
View this message in context: http://elecraft.365791.n2.nabble.com/I-O-output-level-tp7562551p7562853.html
Sent from the Elecraft mailing list archive at Nabble.com.