[Elecraft] KAT100 ATU power metering - a question from VK7JB

[zendoc at netspace.net.au]

Hi Group,

	 

	I've just finished building and calibrating a KAT100 to go with my K2
/ KPA100 combination.  The build was very smooth and the calibration
routine straight forward.  It's tuning my 80m loop, multi-band, just
fine.

	I'd like to check my understanding about the SWR/Power metering with
this K2 + KPA100 + KAT100 set up:

	 

	Is the forward power value displayed  on the LCD of the K2 during
TUNE in this setup being measured by the SWR bridge in the KPA100? 
My understanding  is that the forward power value IS provided by the
KPA100 and NOT the KAT100.

	Is the SWR value displayed on the LCD of the K2 during TUNE
 measured  at the KPA100 or the KPA100 bridge?

	Thanks for the clarification.

	 

	Cheers,

	John

	VK7JB