[Elecraft] K2 Alignment and Test Part 1

[Don Wilhelm]

Cecil,

That is great news.  Enjoy the rest of the build.

73,
Don W3FPR

On 10/26/2012 3:57 PM, Cecil Turquette wrote:
> Don - Appears problem solved.  Pin 4 of the encoder measured "open" to ground.  I messed around for an hour trying to figure out why.  I finally found the wire from the circuit board to the encoder termal #4 broken.  I used trimmed component leads to make the four connections as called out in the book. Apparently the one on #4 had a nick in it; flexing of the wire during assembly of the front panel caused it to break.  The break was well hidden.  I replaced the wire and encoder functions properly.  Ready to move on! Thanks for your help, 73, Cecil
>