[Elecraft] K2 Alignment and Test Part 1

[Don Wilhelm]

End of first paragraph - should be ohms instead of volts.

73,
Don W3FPR
------------------------------------------------
Cecil,

I suggest you check the soldering on the front panel board, be 
especially aware that on all ICs pin 1 is soldered, that is easy to miss.
Check the schematic for the front panel board and look at the symbol for 
the encoder.  Measure to make certain you have 5 volts on the 5 volt pin 
(measure at the encoder terminal not the board), then turn power off and 
measure the resistance from the encoder ground terminal and ground - 
expect zero volts.