[Elecraft] K3 Parts transfer between rigs

[Mike K2MK]

Hi Keith,

You should review the KRX3 assembly/installation manual. There's a resistor
that may need to be modified (see page 21) and maybe some other stuff as
well. 

73,
Mike K2MK


Keith Heimbold wrote
> I have sent my Elmer tech friend a couple emails asking him if he swapped
> out the other boards. If he did not, we will have to get that done and see
> if the errors are eradicated. This is a set back for sure but it gives me
> an opportunity to better understand the K3 and its component parts. 
> 
> I will also contact tech support to see what is going on with the error
> codes. It appears that I also received a ERR DVR error code to top it off
> after I sent the email to the reflector.
> 
> Keith
> AG6AZ
> 
> Sent from my iPhone please excuse typos
> 
> On Oct 19, 2012, at 5:07 AM, "Don Wilhelm" <

> w3fpr@

> > wrote:
> 
>> Was the DSP2 board and the synthesizer board for the KRX3 transferred
>> from the other K3.  From the errors you are getting, it would seem that
>> they were not.
>> 
>> Did your tech elmer just do the unplugging/replugging job or did he check
>> the result out after each option was transferred?  What did he say when
>> you asked him for his observations.
>> 
>> You may have to contact Elecraft support with your error codes.
>> 
>> 73,
>> Don W3FPR





--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-Parts-transfer-between-rigs-tp7564314p7564329.html
Sent from the Elecraft mailing list archive at Nabble.com.