[Elecraft] [K2] Displayed frequency question.

[Don Wilhelm]

Gil,

You will have to do CAL PLL and CAL FIL after properly setting the 4 MHz 
reference oscillator Control Board C22.  The "magic" is in setting C22 
properly.

To accomplish that, go to my website www.w3fpr.com and follow the 
instructions given in the K2 Dial Calibration article.

73,
Don W3FPR

On 10/4/2012 1:00 AM, Gil G. wrote:
> Hello,
>
> When I listen to a station transmitting using CW on, say, 7030 (zero-beat), my displayed frequency is 7029.93.
> When I transmit, the reverse beacon stations show me as being right on 7030 while my displayed frequency is 7029.93.
> When I listen to SSB, station usually do sound perfectly clear at a displayed frequency 70Hz below their advertised frequency (nets).
>
> Should I change my displayed frequency? To what? Am I off?
> If I move the BFO frequency a bit, would I need to realign my filters?
>
> Thanks!
>
> Gil.
> --
> PGP Key: http://keskydee.com/gil.asc
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>