[Elecraft] [K2] Displayed frequency question.

[W0WFH Bill]

Gil:
I am new to the Elecraft K2, I also have the same
problem except mine is reading up in frwquency
when I am tuned into 3.963.00 net my dial reading
is 3.963.21.  I double check net frequency with
my ft 920 and they are dead on 3.963.00.  
 
I need help where to begin looking!
 
Thanks Bill W0WFH
w0wfh at yahoo.com


________________________________
From: Gil G. <gil at keskydee.com>
To: Elecraft at mailman.qth.net 
Sent: Thursday, October 4, 2012 12:00 AM
Subject: [Elecraft] [K2] Displayed frequency question.

Hello,

When I listen to a station transmitting using CW on, say, 7030 (zero-beat), my displayed frequency is 7029.93.
When I transmit, the reverse beacon stations show me as being right on 7030 while my displayed frequency is 7029.93.
When I listen to SSB, station usually do sound perfectly clear at a displayed frequency 70Hz below their advertised frequency (nets).

Should I change my displayed frequency? To what? Am I off?
If I move the BFO frequency a bit, would I need to realign my filters?

Thanks!

Gil.
--
PGP Key: http://keskydee.com/gil.asc

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net/
Please help support this email list: http://www.qsl.net/donate.html