[Elecraft] K2 - PSK31 question

[Gerald Manthey]

Hello Tom
I run the K2 and psk31. It's fun, just remember set your power low. 5 watts
on k2/10 . As far as the mic, I am not sure.
Good luck hope to see you on the waterfall.
KC6CNN
On Nov 27, 2012 5:30 PM, "Tom McCulloch" <thom2 at att.net> wrote:

>
> Hi gang,
>   I have a very old Rig Blaster interface that uses jumpers to match the
> transceiver's  microphone to the Rig Blaster outputs.  The instructions are
> quite old and they don't list the jumper configuration for Elecraft rigs.
>  I seem to remember that the K2 mic jack is configured the same as a
> Kenwood.  Could someone please verify this for me.
>
> Also, is there anything I should know about running psk31 with a barefoot
> K2?
>
> Thanks in advance.
>
> Tom, WB2QDG
> K2 #1103
>
>
> ______________________________**______________________________**__
> Elecraft mailing list
> Home: http://mailman.qth.net/**mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>
> Help: http://mailman.qth.net/mmfaq.**htm<http://mailman.qth.net/mmfaq.htm>
> Post: mailto:Elecraft at mailman.qth.**net <Elecraft at mailman.qth.net>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>