[Elecraft] No CW decode on K3 or P3

[Irizarry, Michael S]

Also try and use "spot" to center it under "cwt" or it won't decode very well. I just tried it and it works with some of the cw machine guns operating in contest. Got to have a decent signal though.

----- Original Message -----
From: Matt Zilmer [mailto:mzilmer at verizon.net]
Sent: Saturday, November 24, 2012 01:20 PM
To: Mike Weir <ve3wdm at hotmail.com>
Cc: elecraft at mailman.qth.net <elecraft at mailman.qth.net>
Subject: Re: [Elecraft] No CW decode on K3 or P3

Make sure you have TEXT DEC enabled.  Narrow the bandwidth, set THR to
2 or so, 30-90 WPM.  

My notes here say it was working fine on 4.51 / 1.17.

73,
matt W6NIA


On Sat, 24 Nov 2012 09:50:06 -0500, you wrote:

>
>Im in the CQ WW and some are just sending at bullet speed have noticed K3 and P3 are not decoding anything. On the K3 just the VFO freq is displayed it does not even attempt to show code. I have the test dec set to 30-90 (have tried other settings) and threshold has tried all as well. Is there a setting in the K3 were I shut down the decode?? Firmware is 4.51 on K3 and on P3 1.17
>Mike
>VE3WDM
> 		 	   		  
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html