[Elecraft] K3 Firmware 4.58 - Problem using K144XV

[hawley, charles j jr]

Has the revised beta been published yet on the web site?

Sent from my iPad
Chuck, KE9UW 
(Jack for BMW motorcycles)

On Nov 16, 2012, at 10:08 AM, "Wayne Burdick" <n6kr at elecraft.com> wrote:

> I just fixed this and will send you the new firmware to test. It  
> should be up on the web site later today.
> 
> Wayne
> N6KR
> 
> 
> On Nov 16, 2012, at 12:56 AM, Geoffrey Downs wrote:
> 
>> Yes my K3/K144XV does the same. When it showed 181 MHz on the VFO A  
>> display
>> (after entering 145) ERR PL1 also appeared briefly on the VFO B  
>> display.
>> Then, after using the bandswitch to go to 2m the VFO A display  
>> started with
>> 144.000 MHz but on subsequent visits to 2m via the bandswitch it  
>> stayed
>> where I had left it, as normal, and did not revert to 144.000 MHz
>> 
>> 73 to all
>> Geoff
>> G3UCK
>> 
>> -----Original Message-----
>> From: Lothar Sack
>> Sent: Thursday, November 15, 2012 10:58 PM
>> 
>> I am using my K3 with the internal transverter K144XV. Today I  
>> installed
>> the (beta) Firmware 4.58.
>> My problem: Entering any 2m- QRG, e.g. 144.300 by pushing on the  
>> front panel
>> "FREQ ENT" 1 4 4 . 3 0 0 "ENTER (AFX)" results in changing the K3 to
>> 180.300 MHz
>> e.g. 145.525 results in 181.525 MHz ...
>> Always exactly 36 MHz too much! Also when entering QRGs by my  
>> contesting
>> software via RS232...
>> The only way to activate 2m is using the bandswitch-button - then my  
>> K3
>> starts with 144.000 MHz.
>> 
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html