[Elecraft] K3 Firmware 4.58 - Problem using K144XV

[Wayne Burdick]

I just fixed this and will send you the new firmware to test. It  
should be up on the web site later today.

Wayne
N6KR


On Nov 16, 2012, at 12:56 AM, Geoffrey Downs wrote:

> Yes my K3/K144XV does the same. When it showed 181 MHz on the VFO A  
> display
> (after entering 145) ERR PL1 also appeared briefly on the VFO B  
> display.
> Then, after using the bandswitch to go to 2m the VFO A display  
> started with
> 144.000 MHz but on subsequent visits to 2m via the bandswitch it  
> stayed
> where I had left it, as normal, and did not revert to 144.000 MHz
>
> 73 to all
> Geoff
> G3UCK
>
> -----Original Message-----
> From: Lothar Sack
> Sent: Thursday, November 15, 2012 10:58 PM
>
> I am using my K3 with the internal transverter K144XV. Today I  
> installed
> the (beta) Firmware 4.58.
> My problem: Entering any 2m- QRG, e.g. 144.300 by pushing on the  
> front panel
> "FREQ ENT" 1 4 4 . 3 0 0 "ENTER (AFX)" results in changing the K3 to
> 180.300 MHz
> e.g. 145.525 results in 181.525 MHz ...
> Always exactly 36 MHz too much! Also when entering QRGs by my  
> contesting
> software via RS232...
> The only way to activate 2m is using the bandswitch-button - then my  
> K3
> starts with 144.000 MHz.
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html